Installation Guide of

Wireless Internet Access Server

WRT-2110

Peer to Peer Print Driver Installation for WRT-2110

The installation Steps:

1. Execute the SETUP program. After the SETUP program start, the Wizard will guide you for the installation steps.

2. The Wizard will ask for the install path, in default, it will installed to "Windows Drive\INTERNET".

3. The Wizard browse the network for any available printer. just click on the port you would like to install. Say, SC120610's Port 1. And click on "Add"

4. Then, it ask for if your printer is an EPSON InkJet printer or not. If yes, click on Yes. The Wizard will adjust the spool's registered record of your system. And NO for any non-EPSON InkJet printer..

The pop-up Window will shows the printer port is created.

5. After you make your selection, the Wizard will ask for your printer driver. Please find your Printer Driver to proceed the installation. The Wizard will create a new printer for you. And close the wizard after the printer created.

 If the printer driver is already installed to you system, you can select "Cancel" to finish the Wizard installation.

6.  After the printer creation, you can go to check the printer's property, and you will find the port information as like figure below:

As you can see in the example, we use the "SC120610_P1",  as the printer port. Then, close, the printer on the WRT-2110 now is ready to use.

• If the IP address of your WRT-2110 is changed, please click on "Configure Port" button as above figure to make the change. As soon as click on this button, the pop-up windows will shows as below:

You can either click on "Browse" to find the new WRT-2110, or just key in the new IP address of your WRT-2110. And click on OK to make the change.

• To delete the driver, click on "Start", select "Program", "Internet Broadband Router", find "Uninstall" then press "Uninstall" to remove the driver.